After the
shower head has been used for a long time, it is easy to block due to the water quality and quality, and there will be a problem of poor water flow from the shower. The main reason is that the water and alkali etc. block the water outlet of the shower. Then, many people don't know what to do, so many people don't know what to do. Next, Cixi XinYi Sanitary Wares Co.,Ltd. will share with us what to do when the shower head is blocked.
1. Arrange the filter
I believe many brothers know that for any bathroom products, including faucets, showers, etc., there will be filters to prevent various impurities from blocking the products, so what should I do if the shower is blocked? You should clean the filter screen, remove the shower head, open the inner cover, and then you will find a filter screen, arrange the filter screen, then the water will flow a lot. Arranging the filter screen is the first condition to ensure the flow of water from the shower.
2. Sort out the water holes
If some of the small holes of the shower head in your home are blocked, put water first and see which holes are blocked at the end. Then you have to turn on the shower head of the shower and see that this shower head, which is the same as the shower head, has a lot of small holes. This is where the water comes out. Then we prepare a needle first, and then use the needle to pierce the impurities in the perforation through the small hole that we just saw without water, until there is no impurities in the hole.
What if many holes are blocked? Here is a little trick, that is to remove the head of the shower, and then use vinegar to mix some water, usually the ratio can be kept between 1:4-1:5, and then soak in the solution for a while After two hours, and then sorting, you will find who picked it up and fell off.
3. Pay attention to maintenance
Assuming the shower in your home is still in good shape today, don't take it lightly and start by avoiding it. It is necessary to develop a good habit of showering and bathing. Before each shower, use a towel to wipe the shower outlet of the shower well to avoid residual scale. The water outlet holes of the rubber material can be rubbed with your fingers. If it is stainless steel and copper materials, a paper clip can be used to unclog the water outlet. At the same time, in order to ensure the service life of the shower head (shower), we should install it so that it is not directly under the Yuba, and the distance between the Yuba should be more than 60cm, and often use a soft cloth to stick a little flour to scrub the surface of the shower, so that it As good as new.
The above is the introduction of the treatment method after the shower is blocked. Have you learned it? The sanitary ware commonly used in the shower is easy to accumulate dirt. If your shower has a certain number of years, and the appearance is relatively old. It is still recommended that you replace the shower with a new one. Continued use of such a shower is bad for health. Because many harmful bacteria and impurities may accumulate inside.
-1.jpg)
-1.jpg?imageView2/2/w/400/format/jp2/q/75)
-2.jpg?imageView2/2/w/400/format/jp2/q/75)
英语
西班牙语