The bathroom shower is a must-have household item in the bathroom, and the proper installation height of the shower is a small detail that many people ignore. If you want to create a comfortable bathroom environment, you have to pay attention to these small details. Below, Cixi XinYi Sanitary Wares Co.,Ltd. will tell you the installation height and installation precautions of the
shower head!
First, shower installation height
1. The height of the shower mixing valve from the ground
When we install the shower, the first thing we need to determine is the height of the shower mixing valve from the ground. Generally, before installing the shower, we have already determined the installation place of the shower. Generally, we control it within the height range of about 90~100cm. In this range, we can also fine-tune according to our own height. But generally it should not be higher than 110cm, if it is too high, it may cause the shower head riser to not be installed.
2. The reserved height of the shower faucet
Generally, the reserved wire head of the installed shower faucet is just buried in the wall tile. Covering just right with a decorative cover is fine. Otherwise, it will not look very beautiful. Therefore, when laying pipes, you should first consider reserving the position, which is generally 15mm higher than the rough wall, so that when the tiles are pasted, the silk head can be buried to ensure the appearance of the wall.
3. Spacing reserved for the inner wire elbow of the shower head
The general standard for the spacing reserved for the inner wire elbow of the shower head is about 10~15cm. Generally, when buying a shower head, the seller will give two adapters, so that the water outlet of the mixing valve can be well connected to the hot and cold water outlet on the wall. However, try not to use the adapter to transfer as much as possible, which is more beautiful.
Second, shower installation precautions
1. After the faucet is installed, it must be level and not inclined, about 900-1100mm from the ground. Be careful not to damage the plated surface when using the wrench to install the faucet.
2. Install the shower head into the installation hole and insert the expansion pipe respectively, and fix the wall seat to the wall with self-tapping screws. Note: The wall seat must be on the same centerline as the faucet outlet.
3. Wrap the faucet with cloth 9 before installing the drill hole to prevent the faucet from being soiled and bumped.
4. The installation height "H" of the shower head should be determined according to the actual product during the actual installation.
5. After the shower head is installed and installed, turn on the water inlet switch J to rinse the pipeline thoroughly.
英语
西班牙语